Home Products Sight Inserts Custom Work Vintage Gun Parts Matches Customers
Instructions
Decapper with .40 stem
[pdf]

How to install the Distant Thunder front sight

International Shipping Only

If you're using PayPal, shipping within the United States is calculated at checkout. International customers using PayPal should email or call me before ordering to get a shipping quote, then use this form to add the cost to your shopping cart.

Shipping quote from Jim:

This is the best way to measure a dovetail for custom sizes or to be sure what standard size your rifle requires.

  1. Use two small drill bits of the same size, 1/16" work best.
  2. Place the drill bits in the dovetail with the shank ends set into the the "V"s of the dovetail.
  3. Use your dial calipers to measure between the drill bits. Measure it three times, you should get very nearly the same dimension all three times (+.001").
  4. Just tell me what size drill bits you used and what the measurement was and I can cut the dovetail to fit with just enough to allow for a little fitting.
How to measure a dove-tail mount
Jim Kluskens, O'Hare Tool, Inc., W8515 County Road N, PO Box 138, Niagara, WI 54151, 715-251-3839